[. . . ] To mount on the wall, proceed as follows: - Fix the bracket to the wall respecting the minimum measurements indicated in fig. If the appliance is installed in a room with bath or shower, respect the "safety distances" shown in fig. - Attach the appliance to the top hook of the bracket, then rotate gently until it hooks to the bottom tooth of the bracket (fig. [. . . ] FROST PREVENTION MODE With the function selector in position 3 and the thermostat dial in position , the appliance maintains room temperature at about 5°C, preventing freezing with minimal energy consumption. Models with thermostat only To switch the appliance on turn the dial anticlockwise as far as it will go to maximum position. To switch the appliance off completely, turn the knob to the minimum position, then unplug from the mains. MODELS WITH 24 HOUR TIMER To programme heating, proceed as follows: Check the time on your clock or watch. If it is 10. 00 for example, turn the numbered programmer disk until the number 10 coincides with the pointer L marked on the programmer. Set the periods of time during which you want the appliance to operate by pushing the teeth outwards. The appliance will now function automatically each day at the programmed time. Important: the appliance must always be plugged into the mains socket. - To change the programmed time period, just bring the teeth back to their original position and set the new working periods required. 4 - To use the appliance without programming, push all the teeth outwards. In this case, to turn the appliance off completely, you may also unplug from the mains. MODELS WITH SWIVELLING BASE (ON/OFF pedal switch) A number of models have a swivelling base and ON/OFF pedal switch. The appliance can be manually oriented to an angle of 30° to the right or left to direct the air flow in the preferred direction. To turn the appliance on, set the thermostat dial and function selector (and possibly also the timer) as described above, then press the pedal on the base. MODELS WITH MOTORISED ROTATING BASE Some models have a motorised rotating base. To stop the appliance in the desired position, simply press the pedal again. Models with motorised base are fitted with a tip-over switch which turns the appliance off if it falls over. To restart the appliance, simply place it upright again. IMPORTANT - The appliance is designed and produced for domestic use only. [. . . ] The heater is fitted with a thermal cutout device which switches the heater off in case of accidental overheating (eg. obstruction of air intake and outlet grilles, motor turning slowly or not at all). To reset, unplug the appliance from the mains socket for a few minutes, remove the cause of overheating then plug in again. [. . . ]